How to Install a License Plate Frame

Note:  The “cap end” of the frame should be located on the right side,

so that the drain hole on the bottom rail is down.

 

1. Remove the cap end using the Allen wrench supplied.

2. Place the stainless steel screws supplied (or your own screws) into the holes of the license plate frame, lining up with the mounting holes on your car.

3. Slowly slide your license plate into the frame. BE CAREFUL NOT TO SCRATCH YOUR PLATE OR FRAME.

4. Place the cap onto the end of the frame and screw it back on using the Allen wrench.

FOR THIS NEXT STEP – BE CAREFUL NOT TO SCRATCH YOUR CAR

5. Hold the frame up to the mounting holes in your car. You should be able to see the screw heads through the holes in your license plate. Using the appropriate screwdriver, begin to screw the frame into place by turning one screw a few times and then the other, until both are tight.

 

To clean the frame, simply wash it as you would your car.

Got questions? Call toll free 888.881.4452.

CONGRATULATIONS!

You have just installed America’s finest License Plate Frame